Test Item

WARNING: This page is about a different car, the 2010 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

SOLENOID VALVE

When performing an active test of the ABS function, select "MAIN SIGNALS" for each test item.

For ABS solenoid valve, touch "Up", "Keep", and "Down" on the display screen. For ABS solenoid valve (ACT), touch "Up", "ACT UP", "ACT KEEP" and confirm that solenoid valves operate as shown in the table below.

ACTIVE TEST MODE CHART

Operation

ABS solenoid valve

ABS solenoid valve (ACT)

Keep

Down

ACT UP

ACT KEEP

FR RH SOL

FR RH IN SOL

Off

FR RH OUT SOL

Off

On⁽¹⁾

FR LH SOL

FR LH IN SOL

Off

FR LH OUT SOL

Off

On⁽¹⁾

RR RH SOL

RR RH IN SOL

Off

RR RH OUT SOL

Off

On⁽¹⁾

RR LH SOL

RR LH IN SOL

Off

RR LH OUT SOL

Off

On⁽¹⁾

FR RH ABS SOLENOID (ACT)

FR RH IN SOL

Off

FR RH OUT SOL

Off

CV1

Off

SV1

Off

On⁽¹⁾

Off

FR LH ABS SOLENOID (ACT)

FR LH IN SOL

Off

FR LH OUT SOL

Off

CV1

Off

SV1

Off

On⁽¹⁾

Off

RR RH ABS SOLENOID (ACT)

RR RH IN SOL

Off

RR RH OUT SOL

Off

CV2

Off

SV2

Off

On⁽¹⁾

Off

RR LH ABS SOLENOID (ACT)

RR LH IN SOL

Off

RR LH OUT SOL

Off

CV2

Off

SV2

Off

On⁽¹⁾

Off

⁽¹⁾	On for 1 to 2 seconds after the touch, and then Off

ABS MOTOR

Touch "On" and "Off" on screen. Make sure motor relay and actuator relay operates as shown in table below.

MOTOR RELAY AND ACTUATOR RELAY OPERATION CHART

Operation	On	Off
MOTOR RELAY	On	Off
ACTUATOR RLY	On	On

BOOSTER DRIVE

Touch "Up" and "Down" on the screen. Check that booster drive operates as shown in table below.

CAUTION: Perform active test subject to the conditions below.

Do not operate brake pedal during active test.
Make sure the engine revolution is over 500 rpm.
Make sure the vehicle is not moving.

BOOSTER DRIVE OPERATION CHART

Operation	Up	Down
BST OPER SIG	On	Off
PRESS SENSOR	50 ± 5 bar	0 bar
PRESS SEN2	50 ± 5 bar	0 bar
STOP LAMP SW	On	Off
STP OFF RLY	Off	Off