Diagnosis Procedure
WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DTC OF BCM
Check DTC in "Self Diagnostic Result" mode of "BCM" using CONSULT-III.
Is DTC detected?
YES: Perform the trouble diagnosis related to the detected DTC. Refer to "DTC INDEX ".
NO: GO TO 2.
- CHECK DTC OF TCM
Check DTC in "Self Diagnostic Result" mode of "TCM" using CONSULT-III.
Is DTC detected?
YES: Perform the trouble diagnosis related to the detected DTC. Refer to "DTC INDEX ".
NO: GO TO 3.
- CHECK IPDM E/R SIGNAL CIRCUIT OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect IPDM E/R connector.
- Disconnect transmission range switch connector.
- Check continuity between IPDM E/R harness connector and transmission range switch harness connector.CONNECTOR TERMINALS CONTINUITY REFERENCE CHART
IPDM E/R Transmission range switch Continuity Connector Terminal Connector Terminal E15 48 F27 2 Existed - Check continuity between IPDM E/R harness connector and ground.CONNECTOR TERMINALS CONTINUITY REFERENCE CHART
(+) (-) Continuity IPDM E/R Connector Terminal E15 48 Ground Not existed Is the inspection result normal?
YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".
NO: Repair or replace harness.