Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC OF TCM
Check DTC in "Self Diagnostic Result" mode of "TCM" using CONSULT-III.

Is DTC detected?

YES: Perform the trouble diagnosis related to the detected DTC. Refer to "DTC INDEX ".

NO: GO TO 2.

CHECK BCM INPUT SIGNAL

Turn ignition switch ON.

Check voltage between BCM harness connector and ground.

CONNECTOR TERMINALS VOLTAGE REFERENCE CHART

(+)		(-)	Condition		Voltage (V) (Approx.)
BCM
Connector	Terminal
M70	102	Ground	Selector lever	P or N position	Battery voltage
M70	102	Ground	Selector lever	Other than above	0

Is the inspection result normal?

YES: GO TO 3.

NO: GO TO 4.

REPLACE BCM
1. Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.
  For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
  
  INSPECTION END

CHECK BCM INPUT SIGNAL CIRCUIT

Turn ignition switch OFF.
Disconnect transmission range switch connector.
Disconnect BCM connector.

Check continuity between transmission range switch harness connector and BCM harness connector.

CONNECTOR TERMINALS CONTINUITY REFERENCE CHART

Transmission range switch		BCM		Continuity
Connector	Terminal	Connector	Terminal	Continuity
F27	2	M70	102	Existed

Check continuity between transmission range switch harness connector and ground.

CONNECTOR TERMINALS CONTINUITY REFERENCE CHART

Transmission range switch		Ground	Continuity
Connector	Terminal
F27	2		Not existed

Is the inspection result normal?

YES: GO TO 5.

NO: Repair or replace harness.

CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".

INSPECTION END