Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
Perform inspection in accordance with procedure that confirms DTC.

Which procedure confirms DTC?

DTC confirmation procedure 1: GO TO 2.

DTC confirmation procedure 2: GO TO 5.
CHECK DTC OF BCM
Check DTC in "Self Diagnostic Result" mode of "BCM" using CONSULT-III.

Is DTC detected?

YES: Perform the trouble diagnosis related to the detected DTC. Refer to "DTC INDEX ".

NO: GO TO 3.

CHECK IGNITION SWITCH START SIGNAL

Turn ignition switch OFF.
Disconnect IPDM E/R harness connector.

Check voltage between IPDM E/R harness connector and ground.

CONNECTOR TERMINALS VOLTAGE REFERENCE CHART

(+)		(-)	Condition		Voltage (V)
IPDM E/R
Connector	Terminal
E10	6	Ground	Ignition switch	START position	6 - 16
E10	6	Ground	Ignition switch	Except START position	0 - 1

Is the inspection result normal?

YES: GO TO 4.

NO: Repair or replace harness. Refer to "CVT : WIRING DIAGRAM ".

PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. Reconnect IPDM E/R harness connector.
2. Turn ignition switch ON.
3. Select "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT-III.
4. Touch "ERASE".
5. Perform DTC CONFIRMATION PROCEDURE for DTC B210B. Refer to , "DTC LOGIC ".
  Is DTC detected?
  
  YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".
  
  NO: INSPECTION END
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. Turn ignition switch ON.
2. Select "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT-III.
3. Touch "ERASE".
4. Perform DTC CONFIRMATION PROCEDURE for DTC B210B. Refer to , "DTC LOGIC ".
  Is DTC detected?
  
  YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".
  
  NO: INSPECTION END