LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> M35 Base >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 189 (Engine Control System - Introduction) >> Service Information >> On Board Diagnostic (OBD) System >> Malfunction Indicator Lamp (MIL) >> How To Switch Diagnostic Test Mode >> How to Erase Diagnostic Test Mode II (Self-diagnostic Results)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How to Erase Diagnostic Test Mode II (Self-diagnostic Results)

WARNING: This page is about a different car, the 2010 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set ECM in Diagnostic Test Mode II (Self-diagnostic results). Refer to "HOW TO SET DIAGNOSTIC TEST MODE II (SELF-DIAGNOSTIC RESULTS) ".
  2. Fully depress the accelerator pedal and keep it depressed for more than 10 seconds.

    The emission-related diagnostic information has been erased from the backup memory in the ECM.

  3. Fully release the accelerator pedal, and check that the DTC 0000 is displayed.
scientia non olet · About LEMON Manuals