ICC Brake Switch

WARNING: This page is about a different car, the 2010 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Disconnect ICC brake switch harness connector.

Check continuity between ICC brake switch terminals 1 and 2 under the following conditions.

CONTINUITY REFERENCE CHART

Condition	Continuity
Brake pedal: Fully released	Should exist
Brake pedal: Slightly depressed	Should not exist

If NG, adjust ICC brake switch installation, refer to "INSPECTION AND ADJUSTMENT ", and perform step 3 again.

Fig 1: Checking Harness Continuity Between ICC Brake Switch Terminals 1 And 2

Courtesy of NISSAN MOTOR CO., U.S.A.