Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check ground connections M16, M70. Refer to "GROUND INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Repair or replace ground connections.

1. Disconnect PSP sensor harness connector.
2. Turn ignition switch ON.
3. Check the voltage between PSP sensor harness connector and ground.
   CONNECTOR TERMINAL VOLTAGE CHART
   
   

   PSP sensor		Ground	Voltage (V)
   Connector	Terminal
   F19	3	Ground	Approx. 5

   Fig 1: Checking Voltage Between PSP Sensor Terminal 3 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair open circuit, short to ground or short to power in harness or connectors.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between PSP sensor harness connector and ECM harness connector.
   CONNECTOR TERMINAL CONTINUITY CHART
   
   

   PSP sensor		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F19	1	F106	96	Existed

4. Also check harness for short to ground and short to power.

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair open circuit, short to ground short to power in harness or connectors.

1. Check the continuity between PSP sensor harness connector and ECM harness connector.
   CONNECTOR TERMINAL CONTINUITY CHART
   
   

   PSP sensor		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F19	2	F106	87	Existed

2. Also check harness for short to ground and short to power.

   Is the inspection result normal? 

   YES: GO TO 5.

   NO: Repair open circuit, short to ground or short to power in harness or connectors.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 6.

NO: Replace PSP sensor.

Refer to "DESCRIPTION ".

INSPECTION END