Component Inspection

CHECK ICC STEERING SWITCH

Check resistance between combination switch (spiral cable) harness connector terminals under the following conditions.

Fig 1: Checking Continuity Between Combination Switch Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

TERMINAL RESISTANCE CHART

Combination switch (spiral cable)		Condition	Resistance (Ω)
Connector	Terminals	Condition	Resistance (Ω)
M303	18 and 21	MAIN switch: Pressed	Approx. 0
		LDP switch: Pressed	Approx. 270
		CANCEL switch: Pressed	Approx. 620
		DISTANCE switch: Pressed	Approx. 1, 100
		SET/COAST switch: Pressed	Approx. 1, 810
		RESUME/ACCELERATE switch: Pressed	Approx. 2, 990
		All ICC steering switches: Released	Approx. 5, 420

Is the inspection result normal?

YES: INSPECTION END

NO: Replace ICC steering switch