Diagnosis Procedure
WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUSE
Check for blown fuses.
FUSES SPECIFICATIONSPower source Fuse No. Battery 37 Ignition switch ACC or ON 6 Is the inspection result normal?
Yes: GO TO 2.
No: Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between front display unit harness connector and ground.
CONNECTOR TERMINAL VALUE TABLESignal name Connector No. Terminal No. Ignition switch position Value (Approx.) Battery power supply M203 2 OFF Battery voltage ACC power supply M203 3 ACC Battery voltage Is the inspection result normal?
Yes: GO TO 3.
No: Check harness between front display unit and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect front display unit connector.
- Check continuity between front display unit harness connector and ground.CONNECTOR TERMINAL CONTINUITY TABLE
Signal name Connector No. Terminal No. Ignition switch position Continuity Ground M203 1 OFF Existed 13
Is the inspection result normal?
Yes: INSPECTION END
No: Repair harness or connector.