Self Diagnosis Result
- In CONSULT-III self-diagnosis, self-diagnosis results and error history are displayed collectively.
- The current malfunction indicates "CRNT". The past malfunction indicates "PAST".
- The timing is displayed as "0" if any of the error codes [U1000], [U1010], [U1300] and [U1310] is detected. The counter increases by 1 if the condition is normal at the next ignition switch ON cycle.
Self-diagnosis results display item
SELF-DIAGNOSIS RESULTS DISPLAY ITEM REFERENCE
| Error item | Description | Possible malfunction factor/Action to take |
|---|---|---|
| CAN COMM CIRCUIT [U1000] | CAN communication malfunction is detected. | Perform diagnosis with CONSULT-III, and then repair the malfunctioning parts according to the diagnosis results. Refer to "DIAGNOSIS PROCEDURE ". |
| CONTROL UNIT (CAN) [U1010] | CAN initial diagnosis malfunction is detected. | Replace the AV control unit. |
| CONTROL UNIT (AV) [U1310] | AV communication circuit initial diagnosis malfunction is detected. | |
| Control Unit FLASH-ROM [U1200] | AV control unit malfunction is detected. | |
| Gyro NO CONN [U1201] | ||
| CAN CONT [U1216] | ||
| BLUETOOTH CONN [U1217] | ||
| HDD CONN [U1218] | ||
| HDD READ [U1219] | ||
| XM SERIAL COMM [U1220] | ||
| HDD WRITE [U121A] | ||
| HDD COMM [U121B] | ||
| HDD ACCESS [U121C] | ||
| DSP CONN [U121D] | ||
| DSP COMM [U121E] | ||
| INTERNAL COMM [U121F] | Malfunction is detected in AV control unit power supply and ground circuits. ground circuits. | Check AV control unit power supply and ground circuits. When detecting no malfunction in those components, replace AV control unit. |
| GPS COMM [U1204] | GPS malfunction is detected. | An intermittent error caused by strong radio interference may be detected unless any symptom (GPS reception error, etc.) occurs. Replace the AV control unit if the malfunction occurs constantly. |
| GPS ROM [U1205] | ||
| GPS RAM [U1206] | ||
| GPS RTC [U1207] | ||
| FRONT DISP CONN [U1243] | When either one of the following items is detected:
|
|
| GPS ANTENNA CONN [U1244] | GPS antenna connection malfunction is detected. | GPS antenna. |
| CAMERA CONT CONN [U1250] | Malfunction is detected in camera connection recognition circuit between AV control unit and camera control unit. | Camera-connection recognition circuit between AV control unit and camera control unit. |
| XM ANTENNA CONN [U1258] | Poor connection is detected in satellite radio antenna. |
|
|
Malfunction is detected in AV control unit power supply and ground circuits. ground circuits. | Check AV control unit power supply and ground circuits. When detecting no malfunction in those components, replace AV control unit. |
|
When either one of the following items is detected:
|
Multifunction switch power supply and ground circuits. |
|
When either one of the following items is detected:
|
DVD player power supply and ground circuits. |
|
When either one of the following items is detected:
|
BOSE amp. power supply and ground circuits. |
|
When either one of the following items is detected:
|
Camera control unit power supply and ground circuits. |
|
When either one of the following items is detected:
|
|
|
Malfunction is detected in AV communication circuits between BOSE amp. and camera control unit. | AV communication circuits between BOSE amp. and camera control unit. |
|
Without DVD player models
|
Without DVD player models
|
|
Malfunction is detected in AV communication circuits between multifunction switch and DVD player. | AV communication circuits between multifunction switch and DVD player. |
Without DVD player models
|
Malfunction is detected in AV communication circuits between AV control unit and multifunction switch. | AV communication circuits between AV control unit and multifunction switch. |
With DVD player models
|
||
Without DVD player models
|
Malfunction is detected in AV communication circuits. | Check and repair the short circuit in AV communication circuits. |
With DVD player models
|