LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> M35 x >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0130 To P0430 >> DTC P0181: FTT Sensor >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK GROUND CONNECTION
    1. Turn ignition switch OFF.
    2. Check ground connections M16, M70. Refer to "GROUND INSPECTION ".

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair or replace ground connections.

  2. CHECK DTC WITH "UNIFIED METER AND A/C AMP."

    Refer to "CONSULT-III FUNCTION (METER/M&A) ".

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Go to "FUEL LEVEL SENSOR SIGNAL INSPECTION ".

  3. CHECK FUEL TANK TEMPERATURE SENSOR POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect "fuel level sensor unit and fuel pump (main)" harness connector.
    3. Turn ignition switch ON.
    4. Check the voltage between "fuel level sensor unit and fuel pump (main)" harness connector and ground.
      CONNECTOR TERMINAL VOLTAGE CHART

      Fuel level sensor unit and fuel pump (main) Ground Voltage (V)
      Connector Terminal
      B433 4 Ground Approx. 5
      Fig 1: Checking Voltage Between Fuel Level Sensor Unit And Fuel Pump Terminal 4 And Ground
      G04875130Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: GO TO  5.

      NO: GO TO 4.

  4. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors B418, M66
    • Harness for open or short between ECM and "fuel level sensor unit and fuel pump (main)"

      Repair open circuit, short to ground or short to power in harness or connector.

  5. CHECK FUEL TANK TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect "unified meter and A/C amp." harness connector.
    3. Check the continuity between "fuel level sensor unit and fuel pump (main)" harness connector and "unified meter and A/C amp." harness connector.
      CONNECTOR TERMINAL CONTINUITY CHART

      Fuel level sensor unit and fuel pump (main) Unified meter and A/C amp. Continuity
      Connector Terminal Connector Terminal
      B433 5 M65 58 Existed
    4. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  7.

      NO: GO TO 6.

  6. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors B418, M66
    • Harness for open or short between "fuel level sensor unit and fuel pump (main)" and "unified meter and A/C amp."

      Repair open circuit, short to ground or short to power in harness or connector.

  7. CHECK FUEL TANK TEMPERATURE SENSOR

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 8.

    NO: Replace "fuel level sensor unit and fuel pump (main)".

  8. CHECK INTERMITTENT INCIDENT

    Refer to "DESCRIPTION ".

    INSPECTION END

scientia non olet · About LEMON Manuals