How to Set Diagnostic Test Mode II (Self-diagnostic Results)

WARNING: This page is about a different car, the 2010 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
Repeat the following procedure quickly five times within 5 seconds.
1. Fully depress the accelerator pedal.
2. Fully release the accelerator pedal.
Wait 7 seconds, fully depress the accelerator pedal and keep it depressed for approx. 10 seconds until the MIL starts blinking.
NOTE: Do not release the accelerator pedal for 10 seconds if MIL starts blinking during this period. This blinking is displaying SRT status and is continued for another 10 seconds.
Fully release the accelerator pedal.
ECM has entered to Diagnostic Test Mode II (Self-diagnostic results).

NOTE: Wait until the same DTC (or 1st trip DTC) appears to completely confirm all DTCs.

Fig 1: Accelerator Pedal Pattern
Courtesy of NISSAN MOTOR CO., U.S.A.