Two Trip Detection Logic
When a malfunction is detected for the first time, 1st trip DTC and 1st trip Freeze Frame data are stored in the ECM memory. The MIL will not illuminate at this stage. <1st trip>
If the same malfunction is detected again during the next drive, the DTC and Freeze Frame data are stored in the ECM memory, and the MIL illuminates. The MIL illuminates at the same time the DTC is stored. <2nd trip> The "trip" in the "Two Trip Detection Logic" means a driving mode in which self-diagnosis is performed during vehicle operation. Specific on board diagnostic items will cause the ECM to illuminate or blink the MIL, and store DTC and Freeze Frame data, even in the 1st trip, as shown below.
| x: Applicable -: Not applicable | ||||||||
|---|---|---|---|---|---|---|---|---|
| Items | MIL | DTC | 1st trip DTC | |||||
| 1st trip | 2nd trip | 1st trip displaying | 2nd trip displaying | 1st trip displaying | 2nd trip Displaying | |||
| Blinking | Illuminated | Blinking | Illuminated | |||||
| Misfire (Possible three way catalyst damage) - DTC: P0300 - P0308 is being detected | x | - | - | - | - | - | x | - |
| Misfire (Possible three way catalyst damage) - DTC: P0300 - P0308 is being detected | - | - | x | - | - | x | - | - |
| One trip detection diagnoses (Refer to "EMISSION-RELATED DIAGNOSTIC INFORMATION ".) | - | x | - | - | x | - | - | - |
| Except above | - | - | - | x | - | x | x | - |
When there is an open circuit on MIL circuit, the ECM cannot warn the driver by illuminating MIL when there is malfunction on engine control system.
Therefore, when electrical controlled throttle and part of ECM related diagnoses are continuously detected as NG for 5 trips, ECM warns the driver that engine control system malfunctions and MIL circuit is open by means of operating the fail-safe function.
The fail-safe function also operates when above diagnoses except MIL circuit are detected and demands the driver to repair the malfunction.
| Engine operating condition in fail-safe mode | Engine speed will not rise more than 2, 500 RPM due to the fuel cut |