DTC Confirmation Procedure
- If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON and wait at least 1 second.
- Start engine and let it idle for 1 second.
- Turn ignition switch OFF, wait at least 10 seconds and then turn it ON.
- Repeat steps 3 and 4 for 4 times.
- Check 1st trip DTC.
- If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".