DTC Confirmation Procedure
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
WITH CONSULT-III
- Turn ignition switch ON.
- Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT-III. Then check the "P/N POSI SW" indication under the following conditions.SELECTOR LEVER POSITION CHART
Selector lever position Known-good signal N or P position ON Except above position OFF If NG, go to "DIAGNOSIS PROCEDURE ".
If OK, go to the following step.
- Start engine and warm it up to normal operating temperature.
- Maintain the following conditions for at least 50 consecutive seconds.ENGINE SPEED SPECIFICATION
ENG SPEED 1, 300 - 6, 375 RPM COOLAN TEMP/S More than 70°C (158°F) B/FUEL SCHDL 3.0 - 31.8 msec VHCL SPEED SE More than 64 km/h (40 MPH) Selector lever position Suitable position - Check 1st trip DTC.
- If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".