DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle .

WITH CONSULT-III

Start engine and warm it up to normal operating temperature.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT-III.
Clear the self-learning coefficient by touching "CLEAR".
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Start engine and keep the engine speed between 3, 500 and 4, 000 RPM for 1 minute under no load.
Let engine idle for 1 minute.
Keep engine speed between 2, 500 and 3, 000 RPM for 20 minutes.
Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

WITH GST

Start engine and warm it up to normal operating temperature.
Turn ignition switch OFF and wait at least 10 seconds.
Disconnect mass air flow sensor (1) harness connector.
Start engine and let it idle for at least 5 seconds.
Stop engine and reconnect mass air flow sensor harness connector.
Turn ignition switch ON.
Select Service $03 with GST and check that DTC P0102 is detected.
Select Service $04 with GST and erase the DTC P0102.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

Fig 1: Identifying Mass Air Flow (MAF) Sensor
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine and keep the engine speed between 3, 500 and 4, 000 RPM for 1 minute under no load.
Let engine idle for 1 minute.
Keep engine speed between 2, 500 and 3, 000 RPM for 20 minutes.
Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".