With GST
- Start engine and warm it up to normal operating temperature.
- Select Service $01 with GST.
- Calculate the total value of "Short term fuel trim" and "Long term fuel trim" indications.
Make sure that the total percentage should be within ± 15%.
If OK, go to the following step.
If NG, check the following.
- Intake air leakage
- Exhaust gas leakage
- Incorrect fuel pressure
- Lack of fuel
- Fuel injector
- Incorrect PCV hose connection
- PCV valve
- Mass air flow sensor
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and keep the engine speed between 3, 500 and 4, 000 RPM for at least 1 minute under no load.
- Let engine idle for 1 minute.
- Increase the engine speed to between 4, 000 and 5, 000 RPM and maintain that speed for 10 seconds.
- Fully release accelerator pedal and then let engine idle for approximately 1 minute.
- Check 1st trip DTC.
- If 1st trip DTC is displayed, go to "DIAGNOSIS PROCEDURE ".