LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> M45 Base >> Repair and Diagnosis >> General Information >> Specifications Index >> Common Specs & Procedures >> Common Specs & Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Common Specs & Procedures

M35 & M45 COMMON SPECS & PROCEDURES

System Specification/Procedure
Air Conditioning
  Service SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque See Torque Specifications in text and applicable figures in AUTOMATIC AIR CONDITIONER article.
Axle Nut/Hub Nut
  Front Axle Nut 92 Ft. Lbs. (125 N.m)
  Front Hub Nuts 65 Ft. Lbs. (88 N.m)
  Rear Axle Nut 130 Ft. Lbs. (175 N.m)
Battery SERVICE DATA AND SPECIFICATIONS (SDS)
Brakes
  Bleeding Sequence BLEEDING BRAKE SYSTEM
  Disc Brakes
    Front FRONT DISC BRAKE
    Rear REAR DISC BRAKE
  Torque
    Front Disc Brake See Torque Specifications in text and applicable figures under COMPONENT .
    Rear Disc Brakes See Torque Specifications in text and applicable figures under COMPONENT .
Charging
  Generator ALTERNATOR
  Torque See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
Drive Belts
  Adjustment
    M35 Belt is automatically adjusted by auto tensioner.
    M45 Belt is automatically adjusted by auto tensioner.
  Belt Routing
    M35 See Torque Specifications in applicable figure under DRIVE BELT .
    M45 See Torque Specifications in applicable figure under DRIVE BELTS .
Engine Cooling
  General Service Specifications
    M35 SERVICE DATA AND SPECIFICATIONS (SDS)
    M45 SERVICE DATA AND SPECIFICATIONS (SDS)
  Radiator Cap Pressure 11-14 psi (0.8-1.0 kgf/cm2 , 78-98 kPa)
  Thermostat R & I
    M35 WATER INLET AND THERMOSTAT ASSEMBLY
    M45 THERMOSTAT AND WATER CONTROL VALVE
  Water Pump R & I
    M35 WATER PUMP
    M45 WATER PUMP
Engine Mechanical
  Compression
    M35 GENERAL SPECIFICATIONS
    M45 GENERAL SPECIFICATIONS
  Oil Pressure
(Engine oil temperature at 80°C (176°F))
    Idle 14 psi (1.0 kgf/cm2 , 98 kPa) or more
    2000 RPM 43 psi (3.0 kgf/cm2 , 294 kPa) or more
  Overhaul
    M35 SERVICE DATA AND SPECIFICATIONS (SDS)
    M45 SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque
    M35 See Torque Specifications in text and applicable figures in ENGINE MECHANICAL article.
    M45 See Torque Specifications in text and applicable figures in ENGINE MECHANICAL (VK45DE) article.
Fluid Specifications See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate (Drive Plate) Torque 65 Ft. Lbs. (88.5 N.m)
Fuel System
  Fuel Pressure 51 psi (3.57 kg/cm2 , 350 kPa)
  Fuel Pressure Test Procedure
    M35 FUEL PRESSURE CHECK
    M45 FUEL PRESSURE CHECK
  Fuel Filter Location Fuel filter is attached to Fuel Pump Unit located fuel tank.
Ignition
  Firing Order & Cylinder Identification
    M35 FIRING ORDER & CYLINDER IDENTIFICATION
    M45 FIRING ORDER & CYLINDER IDENTIFICATION
  Ignition Wires (Resistance) Engine is equipped with Coil-On-Plug ignition.
  Ignition Wires (Routing) Engine is equipped with Coil-On-Plug ignition.
  Spark Plugs
    M35 SPARK PLUG
Torque: 14 Ft. lbs. (19.6 N.m)
    M45 SPARK PLUG
Torque: 18 Ft. lbs. (24.6 N.m)
Starting
  Starter
    M35 & M45 STARTER
  Torque
    M35 & M45 See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
Wheel Alignment
  Adjustment Specifications
    Front (2WD) SERVICE DATA AND SPECIFICATIONS (SDS)
    Front (AWD) SERVICE DATA AND SPECIFICATIONS (SDS)
    Rear SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque
    Front (2WD) See Torque Specifications in text and applicable figures under FRONT SUSPENSION .
    Front (AWD) See Torque Specifications in text and applicable figures under FRONT SUSPENSION .
    Rear See Torque Specifications in text and applicable figures under REAR SUSPENSION .
Wheel & Tire
  Lug Nut Torque 80 Ft. Lbs. (108 N.m, 11 kg.m)
How To Use Nissan/Infiniti Service Information
  Includes:
Standard Bolt Torque
Symbol Identification
General Connector Info
GENERAL INFORMATION -- M35-M45