Component Inspection (Dropping Resistor)
WARNING: This page is about a different car, the 2010 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DROPPING RESISTOR
- Turn ignition switch OFF.
- Disconnect dropping resistor harness connector.
- Check resistance between dropping resistor as follows.
TERMINAL RESISTANCE CHART
| Terminals |
Resistance |
| 1 and 2 |
0.9 Ω [at 20°C (68°F)] |
Is the inspection result normal?
YES: INSPECTION END
NO: Replace dropping resistor.
Courtesy of NISSAN MOTOR CO., U.S.A.