DTC Confirmation Procedure
- PRECONDITIONING-I
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
- PRECONDITIONING-II
With CONSULT-III
- Turn ignition switch ON.
- Check the following conditions:AMBIENT TEMPERATURE SPECIFICATION
Ambient temperature -7°C (19°F) or more A/C switch OFF Blower fan switch OFF - Select "DATA MONITOR" mode of "ENGINE" using CONSULT-III.
- Check the following conditions:
COOLAN TEMP SPECIFICATIONCOOLAN TEMP/S -10°C - 69°C (14 - 156°F) Is the condition satisfied?
YES: GO TO 3.
NO:
- PERFORM DTC CONFIRMATION PROCEDURE-I
With CONSULT-III
- Start engine.
- Drive the vehicle until the following condition is satisfied.CAUTION: Always drive vehicle at safe speed.
- STEP 1
Drive the vehicle under the conditions instructed below until the difference between "COOLAN TEMP/S" and "FUEL T/TMP SE" becomes at least 25°C (45°F).
COOLAN TEMP SPECIFICATIONCOOLAN TEMP/S 75°C (167°F) or less FUEL T/TMP SE Less than the value calculated by subtracting 25°C (45°F) from "COOLAN TEMP/S".(1) (1) Example COOLAN TEMP SPECIFICATIONCOOLAN TEMP/S FUEL T/TMP SE 70°C (158°F) 45°C (113°F) or less 65°C (149°F) 40°C (104°F) or less 60°C (140°F) 35°C (95°F) or less - STEP 2
Drive the vehicle at 50 km/h (32 MPH) or more with the difference between "COOLAN TEMP/S" and "FUEL T/TMP SE" maintained at 25°C (45°F) or more.
NOTE: Keep the accelerator pedal as steady as possible during cruising. - STEP 3
Drive the vehicle at 50 km/h (32 MPH) or more until "COOLAN TEMP/S" increases by 6°C (11°F).
NOTE: Keep the accelerator pedal as steady as possible during cruising.
Is the condition satisfied?
YES: GO TO 4.
NO: GO TO 3.
- STEP 1
- PERFORM DTC CONFIRMATION PROCEDURE-II
With CONSULT-III
- Drive the vehicle until the following condition is satisfied.COOLAN TEMP SPECIFICATION
COOLAN TEMP/S 75°C (167°F) or more CAUTION: Always drive vehicle at safe speed. - Check 1st trip DTC.
Is 1st trip DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END
- Drive the vehicle until the following condition is satisfied.