Values On The Diagnosis Tool
WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short-circuited.
CONDITION REFERENCE CHART
| Monitor item | Display content | Data monitor | |||||||
|---|---|---|---|---|---|---|---|---|---|
| Condition | Reference value in normal operation | ||||||||
| FR LH SENSOR | Wheel speed | Vehicle stopped | 0 [km/h (MPH)] | ||||||
| Vehicle running ((1)) | Nearly matches the speedometer display (± 10% or less) | ||||||||
| FR RH SENSOR | Wheel speed | Vehicle stopped | 0 [km/h (MPH)] | ||||||
| Vehicle running ((1)) | Nearly matches the speedometer display (± 10% or less) | ||||||||
| RR LH SENSOR | Wheel speed | Vehicle stopped | 0 [km/h (MPH)] | ||||||
| Vehicle running ((1)) | Nearly matches the speedometer display (± 10% or less) | ||||||||
| RR RH SENSOR | Wheel speed | Vehicle stopped | 0 [km/h (MPH)] | ||||||
| Vehicle running ((1)) | Nearly matches the speedometer display (± 10% or less) | ||||||||
| STOP LAMP SW | Brake pedal operation | When brake pedal is depressed | On | ||||||
| When brake pedal is not depressed | Off | ||||||||
| BATTERY VOLT | Battery voltage supplied to the ABS actuator and electric unit (control unit) | Ignition switch ON | 10 - 16 V | ||||||
| GEAR | Gear position | Vehicle running | 1 - 6 | ||||||
| R POSI SIG | Select shift position | CVT shift position (R) | On | ||||||
| CVT shift position (other R) | Off | ||||||||
| N POSI SIG | Select shift position | CVT shift position (N) | On | ||||||
| CVT shift position (other N) | Off | ||||||||
| P POSI SIG | Select shift position | CVT shift position (P) | On | ||||||
| CVT shift position (other P) | Off | ||||||||
| SLCT LVR POSI | Select shift position | CVT shift position (P, R, N, D, L) | P R N D L |
||||||
| Manual mode | ## | ||||||||
| OFF SW | VDC OFF switch ON/OFF status | VDC OFF switch ON (When VDC OFF indicator lamp is ON) | On | ||||||
| VDC OFF switch OFF (When VDC OFF indicator lamp is OFF) | Off | ||||||||
| YAW RATE SEN | Yaw rate detected by yaw rate/side/decel sensor | Vehicle stopped | Approx. 0 d/s | ||||||
| Vehicle running | -100 to 100 d/s | ||||||||
| DECEL G-SEN | Decel G detected by yaw rate/side/decel G sensor | Vehicle stopped | Approx. 0 G | ||||||
| Vehicle running | -1.7 - +1.7 G | ||||||||
| ACCEL POS SIG | Open/Close condition of throttle valve (Linked with accelerator pedal) | Accelerator pedal not depressed (Engine stopped) | 0 % | ||||||
| Depress accelerator pedal (Engine stopped) | 0 - 100 % | ||||||||
| SIDE G-SENSOR | Transverse G detected by yaw rate/side/decel G sensor | Vehicle stopped | Approx. 0 m/s2 | ||||||
| Vehicle running | - 16.7 - 16.7 m/s2 | ||||||||
| STR ANGLE SIG | Steering angle detected by steering angle sensor | Driving straight | -3.5 - +3.5° | ||||||
| Turn 90° to right | Approx. -90 ° | ||||||||
| Turn 90° to left | Approx. +90 ° | ||||||||
| ENGINE RPM | With engine running | With engine stopped | 0 [tr/min (rpm)] | ||||||
| Engine running | Almost in accordance with tachometer display | ||||||||
| FLUID LEV SW | Brake fluid level switch signal status | When brake fluid level switch ON | On | ||||||
| When brake fluid level switch OFF | Off | ||||||||
| PRESS SENSOR | Brake fluid pressure detected by pressure sensor | With ignition switch ON and brake pedal released | Approx. 0 bar | ||||||
| With ignition switch ON and brake pedal depressed | 0 - 170 bar | ||||||||
| FR RH IN SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| FR RH OUT SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| FR LH IN SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| FR LH OUT SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| RR RH IN SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| RR RH OUT SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| RR LH IN SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| RR LH OUT SOL ((2)) | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| MOTOR RELAY | Motor and motor relay operation | Ignition switch ON or engine running (ABS operated) | On | ||||||
| Ignition switch ON or engine running (ABS not operated) | Off | ||||||||
| ACTUATOR RLY ((2)) | Actuator relay operation | Vehicle stopped (Engine running) | On | ||||||
| Vehicle stopped (Ignition switch ON) | Off | ||||||||
| ABS WARN LAMP | ABS warning lamp ((3)) | When ABS warning lamp is ON | On | ||||||
| When ABS warning lamp is OFF | Off | ||||||||
| OFF LAMP | VDC OFF indicator lamp ((3)) | When VDC OFF indicator lamp is ON | On | ||||||
| When VDC OFF indicator lamp is OFF | Off | ||||||||
| SLIP/VDC LAMP | SLIP indicator lamp ((3)) | When SLIP indicator lamp is ON | On | ||||||
| When SLIP indicator lamp is blinking | |||||||||
| When SLIP indicator lamp is OFF | Off | ||||||||
| CV1 | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| CV2 | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| SV1 | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| SV2 | Operation status of each solenoid valve | Actuator (solenoid valve) is active ("ACTIVE TEST" in "ABS" with CONSULT) | On | ||||||
| When the actuator (solenoid valve) is not active and actuator relay is active (ignition switch ON) | Off | ||||||||
| EBD SIGNAL | EBD operation | EBD is active | On | ||||||
| EBD is inactive | Off | ||||||||
| ABS SIGNAL | ABS operation | ABS is active | On | ||||||
| ABS is inactive | Off | ||||||||
| TCS SIGNAL | TCS operation | TCS is active | On | ||||||
| TCS is inactive | Off | ||||||||
| VDC SIGNAL | VDC operation | VDC is active | On | ||||||
| VDC is inactive | Off | ||||||||
| EBD FAIL SIG | EBD fail-safe signal | In EBD fail-safe | On | ||||||
| EBD is normal | Off | ||||||||
| ABS FAIL SIG | ABS fail-safe signal | In ABS fail-safe | On | ||||||
| ABS is normal | Off | ||||||||
| TCS FAIL SIG | TCS fail-safe signal | In TCS fail-safe | On | ||||||
| TCS is normal | Off | ||||||||
| VDC FAIL SIG | VDC fail-safe signal | In VDC fail-safe | On | ||||||
| VDC is normal | Off | ||||||||
| EBD WARN LAMP | Brake warning lamp ((3)) | When brake warning lamp is ON | On | ||||||
| When brake warning lamp is OFF | Off | ||||||||
| CRANKING SIG | Crank operation | Crank is active | On | ||||||
| Crank is inactive | Off | ||||||||
| 4WD FAIL REQ | AWD fail status | AWD fail | On | ||||||
| AWD normal | Off | ||||||||
| 2WD/4WD | Drive axle | 2WD model | 2WD | ||||||
| AWD model | 4WD | ||||||||
|
|||||||||