ECM : Work Procedure

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Insert the registered Intelligent key* into key slot, then turn ignition switch ON.
  *: To perform this step, use the key that was used before performing ECM replacement.
3. Maintain ignition switch in the ON position for at least 5 seconds.
4. Turn power supply position to OFF.
5. Verify that the engine starts.
  GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform the following procedure, , "WORK PROCEDURE ".

END