LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2011 >> FX35 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (VQ35HR) - FX35 - Diagnostics Introduction & DTC Index >> System Description >> Diagnosis System (ECM) >> CONSULT-III Function >> Work Support Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Support Mode

Work Item

WORK SUPPORT MODE REFERENCE CHART

WORK ITEM CONDITION USAGE
FUEL PRESSURE RELEASE
  • Fuel pump will stop by touching "START" during idling. Crank a few times after engine stalls.
 When releasing fuel pressure from fuel line
IDLE AIR VOL LEARN
  • The idle air volume that keeps the engine within the specified range is memorized in ECM.
 When learning the idle air volume
SELF-LEARNING CONT
  • The coefficient of self-learning control mixture ration returns to the original coefficient.
 When clearing mixture ratio self-learning value
EVAP SYSTEM CLOSE Close the EVAP canister vent control valve in order to make EVAP system close under the following conditions.
  • Ignition switch ON
  • Engine not running
  • Ambient temperature is above 0°C (32°F).
  • No vacuum and no high pressure in EVAP system
  • Fuel tank temperature. Is more than 0°C (32°F).
  • Within 10 minutes after starting "EVAP SYSTEM CLOSE"
  • When trying to execute "EVAP SYSTEM CLOSE" under the condition except above, CONSULT-III will discontinue it and display appropriate instruction.
NOTE: When starting engine, CONSULT-III may display "BATTERY VOLTAGE IS LOW. CHARGE BATTERY", even when using a charged battery.
 When detecting EVAP vapor leak in the EVAP system
VIN REGISTRATION
  • In this mode, VIN is registered in ECM.
 When registering VIN in ECM
EXH V/T CONTROL LEARN
  • In this mode, operation to learn exhaust valve timing control magnet retarder characteristic.
 When learning the exhaust valve timing control
TARGET IDLE RPM ADJ(1)
  • Idle condition
 When setting target idle speed
TARGET IGN TIM ADJ(1)
  • Idle condition
 When adjusting target ignition timing
CLSD THL POS LEARN(2)
  • Ignition on and engine stopped.
 When learning the throttle valve closed position
(1) This function is not necessary in the usual service procedure.
(2) TYPE B
scientia non olet · About LEMON Manuals