Component Inspection
- CHECK THROTTLE POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Perform "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
- Turn ignition switch ON.
- Set selector lever to D (A/T) or 1st (M/T) position.
- Check the voltage between ECM harness connector terminals under the following conditions.VOLTAGE REFERENCE CHART
ECM Condition Voltage (V) Connector + - Terminal F101 30 [TP sensor 1 (bank 1)] 40 Accelerator pedal Fully released More than 0.36 Fully depressed Less than 4.75 31 [TP sensor 1 (bank 2)] 48 Fully released More than 0.36 Fully depressed Less than 4.75 34 [TP sensor 2 (bank 1)] 40 Fully released Less than 4.75 Fully depressed More than 0.36 35 [TP sensor 2 (bank 2)] 48 Fully released Less than 4.75 Fully depressed More than 0.36 Is the inspection result normal?
YES: INSPECTION END
NO: Go to 2.
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
- Replace malfunctioning electric throttle control actuator. Refer to "EXPLODED VIEW ".
- Go to
"SPECIAL REPAIR REQUIREMENT ".
INSPECTION END