LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2011 >> G37 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Security Control System -- G25/G37 Sedan) >> DTC/Circuit Diagnosis >> DTC B2602: Shift Position >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC WITH "ABS ACTUATOR AND ELECTRIC UNIT"

    Check "Self diagnostic result" using CONSULT-III. Refer to "DTC NO. INDEX ".

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Repair or replace the malfunctioning parts.

  2. CHECK A/T SHIFT SELECTOR POWER SUPPLY
    1. Turn ignition switch OFF.
    2. Disconnect A/T shift selector (detention switch) connector.
    3. Check voltage between A/T shift selector (detention switch) harness connector and ground.
      TERMINAL VOLTAGE REFERENCE CHART

      (+) (-) Voltage (V) (Approx.)
      A/T shift selector (detention switch)
      Connector Terminal
      M137 10 Ground Battery voltage

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: GO TO 3.

  3. CHECK A/T SHIFT SELECTOR POWER SUPPLY CIRCUIT
    1. Disconnect BCM connector.
    2. Check continuity between A/T shift selector (detention switch) harness connector and BCM harness connector.
      TERMINAL CONTINUITY REFERENCE CHART

      A/T shift selector (detention switch) BCM Continuity
      Connector Terminal Connector Terminal
      M137 10 M122 96 Existed
    3. Check continuity between A/T shift selector (detention switch) harness connector and ground.
      TERMINAL CONTINUITY REFERENCE CHART

      A/T shift selector (detention switch) Ground Continuity
      Connector Terminal
      M137 10 Not existed

      Is the inspection result normal? 

      YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

  4. CHECK A/T SHIFT SELECTOR CIRCUIT
    1. Disconnect BCM connector and IPDM E/R connector.
    2. Check continuity between A/T shift selector (detention switch) harness connector and BCM harness connector.
      TERMINAL CONTINUITY REFERENCE CHART

      A/T shift selector (detention switch) BCM Continuity
      Connector Terminal Connector Terminal
      M137 11 M122 99 Existed
    3. Check continuity between A/T shift selector (detention switch) harness connector and ground.
      TERMINAL CONTINUITY REFERENCE CHART

      A/T shift selector (detention switch) Ground Continuity
      Connector Terminal
      M137 11 Not existed

      Is the inspection result normal? 

      YES: GO TO 5.

      NO: Repair or replace harness.

  5. CHECK A/T SHIFT SELECTOR (DETENTION SWITCH)

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 6.

    NO: Replace A/T shift selector. Refer to "2WD : REMOVAL AND INSTALLATION " (2WD) or "AWD : REMOVAL AND INSTALLATION " (AWD).

  6. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    INSPECTION END

scientia non olet · About LEMON Manuals