LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2011 >> G37 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Audio System, Visual System & Navigation System (BOSE Audio With Navigation) -- G37 Convertible) >> DTC/Circuit Diagnosis >> Camera Image Signal Circuit >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK CONTINUITY CAMERA POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect AV control unit connector and rear view camera connector.
    3. Check continuity between AV control unit harness connector and rear view camera harness connector.
      TERMINALS CONTINUITY REFERENCE CHART

      AV control unit Rear view camera Continuity
      Connector Terminal Connector Terminal
      M209 22 B311 1 Existed
    4. Check continuity between AV control unit harness connector and ground.
      TERMINALS CONTINUITY REFERENCE CHART

      AV control unit Ground Continuity
      Connector Terminal
      M209 22 Not existed

      Is inspection result normal? 

      YES: Go to 2.

      NO: Repair harness or connector.

  2. CHECK VOLTAGE CAMERA POWER SUPPLY
    1. Connect AV control unit connector and rear view camera connector.
    2. Turn ignition switch ON.
    3. Shift the selector lever to "R".
    4. Check voltage between AV control unit harness connector and ground.
      TERMINALS VOLTAGE REFERENCE CHART

      (+) (-) Condition Voltage (Approx.)
      AV control unit
      Connector Terminal
      M209 22 Ground Shift position is "R". 6.0 V

      Is inspection result normal? 

      YES: Go to 3.

      NO: Replace AV control unit.

  3. CHECK CONTINUITY CAMERA IMAGE SIGNAL CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect display unit connector and rear view camera connector.
    3. Check continuity between display unit harness connector and rear view camera harness connector.
      TERMINALS CONTINUITY REFERENCE CHART

      Display unit Rear view camera Continuity
      Connector Terminal Connector Terminal
      M75 8 B311 3 Existed
    4. Check continuity between display unit harness connector and ground.
      TERMINALS CONTINUITY REFERENCE CHART

      Display unit Ground Continuity
      Connector Terminal
      M75 8 Not existed

      Is inspection result normal? 

      YES: Go to 4.

      NO: Repair harness or connector.

  4. CHECK CAMERA IMAGE SIGNAL
    1. Connect display unit connector and rear view camera connector.
    2. Turn ignition switch ON.
    3. Shift the selector lever to "R".
    4. Check signal between display unit harness connector and ground.
      TERMINALS SIGNAL REFERENCE CHART

      (+) (-) Condition Reference value
      Display unit
      Connector Terminal
      M75 8 Ground At rear view camera image is displayed.
      G07161579Courtesy of NISSAN MOTOR CO., U.S.A.

      Is inspection result normal? 

      YES: Replace display unit. Refer to "EXPLODED VIEW ".

      NO: Replace rear view camera. Refer to "EXPLODED VIEW ".

scientia non olet · About LEMON Manuals