AV CONTROL UNIT : Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FUSE

Check for blown fuses.

FUSE REFERENCE CHART

Power source	Fuse No.
Battery	34

Is the inspection result normal?

YES: Go to 2.

NO: Be sure to eliminate cause of malfunction before installing new fuse.

CHECK BATTERY POWER SUPPLY CIRCUIT

Check voltage between AV control unit harness connector and ground.

TERMINALS VOLTAGE REFERENCE CHART

Signal name	Connector No.	Terminal No.	Ignition switch position	Value (Approx.)
Battery power supply	M208	19	OFF	Battery voltage

Is the inspection result normal?

YES: Go to 3.

NO: Check harness between AV control unit and fuse.

CHECK ACC POWER SUPPLY CIRCUIT

Check voltage between AV control unit harness connector and ground.

TERMINALS VOLTAGE REFERENCE CHART

Signal name	Connector No.	Terminal No.	Ignition switch position	Value (Approx.)
ACC power supply	M208	7	ACC	Battery voltage

Is the inspection result normal?

YES: Go to 4.

NO: Check harness between AV control unit and BCM.

CHECK GROUND CIRCUIT

Check continuity between AV control unit harness connectors and ground.

TERMINALS CONTINUITY REFERENCE CHART

Signal name	Connector No.	Terminal No.	Ignition switch position	Continuity
Ground	M208	20	OFF	Existed

Is the inspection result normal?

YES: INSPECTION END

NO: Repair harness or connector.