TEL ADAPTER UNIT : Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK FUSE
Check for blown fuses.
FUSES REFERENCE CHARTPower source Fuse No. Battery 34 Ignition switch ACC or ON 19 Is the inspection result normal?
YES: Go to 2.
NO: Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between TEL adapter unit harness connector and ground.
VOLTAGE REFERENCE CHARTSignal name Connector No. Terminal No. Ignition switch position Value (Approx.) Battery power supply B237 1 OFF Battery voltage ACC power supply B237 2 ACC Battery voltage Is the inspection result normal?
YES: Go to 3.
NO: Check harness between TEL adapter unit and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect TEL adapter unit connector.
- Check continuity between TEL adapter unit harness connector and ground.CONTINUITY REFERENCE CHART
Signal name Connector No. Terminal No. Ignition switch position Continuity Ground B237 4, 14 OFF Existed Is the inspection result normal?
YES: INSPECTION END
NO: Repair harness or connector.