Front Wiper Control
WARNING: This page is about a different variant/trim than selected.
IPDM E/R detects front wiper stop position by a front wiper stop position signal.
When a front wiper stop position signal is in the conditions listed below, IPDM E/R stops power supply to wiper after repeating a front wiper 10 seconds activation and 20 seconds stop five times.
FRONT WIPER CONTROL REFERENCE CHART
| Ignition switch | Front wiper switch | Front wiper stop position signal |
|---|---|---|
| ON | OFF | The front wiper stop position signal (stop position) cannot be input for 10 seconds. |
| ON | The front wiper stop position signal does not change for 10 seconds. |
NOTE:
This operation status can be confirmed on the IPDM E/R "Data Monitor" that displays "BLOCK" for the item "WIP PROT" while the wiper is stopped.