Power Supply Position Change Table By Push-Button Ignition Switch Operation
WARNING: This page is about a different variant/trim than selected.
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when it is inserted to the key slot, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions,
A/T models
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
M/T models
- Clutch pedal operating condition
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
POWER SUPPLY POSITION CHANGE CHART
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| A/T models | M/T models | |||
| Selector lever position | Brake pedal operation condition | Clutch pedal operation condition | ||
| LOCK → ACC | - | Not depressed | Not depressed | 1 |
| LOCK → ACC → ON | - | Not depressed | Not depressed | 2 |
| LOCK → ACC → ON → OFF | - | Not depressed | Not depressed | 3 |
| LOCK → START ACC → START ON → START |
P or N position | Depressed | Depressed | 1 |
| Engine is running → OFF | - | - | - | 1 |
Vehicle speed: 4 km/h (2.5 MPH) or more
POWER SUPPLY POSITION CHANGE CHART
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| A/T models | M/T models | |||
| Selector lever position | Brake pedal operation condition | Clutch pedal operation condition | ||
| Engine is running → ACC | - | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | Depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.