Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Disconnect VVEL control module harness connector.
4. Check the continuity between ECM harness connector and VVEL control module harness connector.
   CONTINUITY REFERENCE
   
   

   ECM		VVEL control module		Continuity
   Connector	Terminal	Connector	Terminal
   F102	54	E15	24	Existed
   	55		11

5. Also check harness for short to ground and power.

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

Check the following.

• Harness connector E20, F40
• Harness for open or short between ECM and VVEL control module

  Repair open circuit or short to ground or short to power in harness or connectors.

Refer to "INTERMITTENT INCIDENT ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Repair or replace.

1. Replace VVEL control module.
2. Go to "WORK PROCEDURE ".

   GO TO 5.

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Erase DTC.
4. Perform DTC Confirmation Procedure.

   See "DTC LOGIC ".

5. Check DTC.

   Is the DTC U1003 displayed again? 

   YES: GO TO 6.

   NO: INSPECTION END

1. Replace ECM.
2. Go to "WORK PROCEDURE ".

   INSPECTION END