Values On The Diagnosis Tool
NOTE:
- Specification data are reference values.
- Specification data are output/input values which are detected or supplied by the ECM at the connector.
* Specification data may not be directly related to their components signals/values/operations.
i.e. Adjust ignition timing with a timing light before monitoring IGN TIMING, because the monitor may show the specification data in spite of the ignition timing not being adjusted to the specification data. This IGN TIMING monitors the data calculated by the ECM according to the signals input from the camshaft position sensor and other ignition timing related sensors.
CONSULT-III MONITOR ITEM
CONDITION REFERENCE
| Monitor Item | Condition | Values/Status | |||||
|---|---|---|---|---|---|---|---|
| ENG SPEED |
|
Almost the same speed as the tachometer indication | |||||
| MAS A/F SE-B1 | See "DESCRIPTION ". | ||||||
| MAS A/F SE-B2 | See "DESCRIPTION ". | ||||||
| B/FUEL SCHDL | See "DESCRIPTION ". | ||||||
| A/F ALPHA-B1 | See "DESCRIPTION ". | ||||||
| A/F ALPHA-B2 | See "DESCRIPTION ". | ||||||
| COOLAN TEMP/S |
|
Indicates engine coolant temperature | |||||
| A/F SEN1 (B1) |
|
Maintaining engine speed at 2, 000 RPM | Fluctuates around 2.2 V | ||||
| A/F SEN1 (B2) |
|
Maintaining engine speed at 2, 000 RPM | Fluctuates around 2.2 V | ||||
| HO2S2 (B1) |
|
0 - 0.3 V ↔ Approx. 0.6 - 1.0 V | |||||
| HO2S2 (B2) |
|
0 - 0.3 V ↔ Approx. 0.6 - 1.0 V | |||||
| HO2S2 MNTR (B1) |
|
LEAN ↔ RICH | |||||
| HO2S2 MNTR (B2) |
|
LEAN ↔ RICH | |||||
| VHCL SPEED SE |
|
Almost the same speed as speedometer indication | |||||
| BATTERY VOLT |
|
11 - 14 V | |||||
| ACCEL SEN 1 |
|
Accelerator pedal: Fully released | 0.45 - 1.00 V | ||||
| Accelerator pedal: Fully depressed | 4.4 - 4.8 V | ||||||
| ACCEL SEN 2(1) |
|
Accelerator pedal: Fully released | 0.45 - 1.00 V | ||||
| Accelerator pedal: Fully depressed | 4.3 - 4.8 V | ||||||
| TP SEN 1-B1 |
|
Accelerator pedal: Fully released | More than 0.36 V | ||||
| Accelerator pedal: Fully depressed | Less than 4.75 V | ||||||
| TP SEN 2-B1(1) |
|
Accelerator pedal: Fully released | More than 0.36 V | ||||
| Accelerator pedal: Fully depressed | Less than 4.75 V | ||||||
| FUEL T/TMP SE |
|
Indicates fuel tank temperature | |||||
| INT/A TEMP SE |
|
Indicates intake air temperature | |||||
| EVAP SYS PRES |
|
Approx. 1.8 - 4.8 V | |||||
| FUEL LEVEL SE |
|
Depending on fuel level of fuel tank | |||||
| START SIGNAL |
|
OFF → ON → OFF | |||||
| CLSD THL POS |
|
Accelerator pedal: Fully released | ON | ||||
| Accelerator pedal: Slightly depressed | OFF | ||||||
| AIR COND SIG |
|
Air conditioner switch: OFF | OFF | ||||
| Air conditioner switch: ON (Compressor operates.) | ON | ||||||
| P/N POSI SW |
|
Selector lever: P or N | ON | ||||
| Selector lever: Except above | OFF | ||||||
| PW/ST SIGNAL |
|
Steering wheel: Not being turned | OFF | ||||
| Steering wheel: Being turned | ON | ||||||
| LOAD SIGNAL |
|
Rear window defogger switch: ON and/or Lighting switch: 2nd position |
ON | ||||
| Rear window defogger switch and lighting switch: OFF | OFF | ||||||
| IGNITION SW |
|
ON → OFF → ON | |||||
| HEATER FAN SW |
|
Heater fan switch: ON | ON | ||||
| Heater fan switch: OFF | OFF | ||||||
| BRAKE SW |
|
Brake pedal: Fully released | OFF | ||||
| Brake pedal: Slightly depressed | ON | ||||||
| INJ PULSE-B1 |
|
Idle | 2.0 - 3.0 msec | ||||
| 2, 000 RPM | 1.9 - 2.9 msec | ||||||
| INJ PULSE-B2 |
|
Idle | 2.0 - 3.0 msec | ||||
| 2, 000 RPM | 1.9 - 2.9 msec | ||||||
| IGN TIMING |
|
Idle | 7° BTDC | ||||
| 2, 000 RPM | 25° - 45° BTDC | ||||||
| CAL/LD VALUE |
|
Idle | 5% - 35% | ||||
| 2, 500 RPM | 5% - 35% | ||||||
| MASS AIRFLOW |
|
Idle | 2.0 - 6.0 g/s | ||||
| 2, 500 RPM | 7.0 - 20.0 g/s | ||||||
| PURG VOL C/V |
|
Idle (Accelerator pedal: Not depressed even slightly, after engine starting.) | 0% | ||||
| 2, 000 RPM | - | ||||||
| INT/V TIM (B1) |
|
Idle | - 5 - 5°CA | ||||
| 2, 000 RPM | Approx. 0 - 30°CA | ||||||
| INT/V TIM (B2) |
|
Idle | - 5 - 5°CA | ||||
| 2, 000 RPM | Approx. 0 - 30°CA | ||||||
| INT/V SOL (B1) |
|
Idle | 0 - 2% | ||||
| 2, 000 RPM | Approx. 0 - 50% | ||||||
| INT/V SOL (B2) |
|
Idle | 0 - 2% | ||||
| 2, 000 RPM | Approx. 0 - 50% | ||||||
| TP SEN 1-B2 |
|
Accelerator pedal: Fully released | More than 0.36 V | ||||
| Accelerator pedal: Fully depressed | Less than 4.75 V | ||||||
| TP SEN 2-B2(1) |
|
Accelerator pedal: Fully released | More than 0.36 V | ||||
| Accelerator pedal: Fully depressed | Less than 4.75 V | ||||||
| AIR COND RLY |
|
Air conditioner switch: OFF | OFF | ||||
| Air conditioner switch: ON (Compressor operates) | ON | ||||||
| FUEL PUMP RLY |
|
ON | |||||
|
OFF | ||||||
| VENT CONT/V |
|
OFF | |||||
| THRTL RELAY |
|
ON | |||||
| HO2S2 HTR (B1) |
|
ON | |||||
|
OFF | ||||||
| HO2S2 HTR (B2) |
|
ON | |||||
|
OFF | ||||||
| I/P PULLY SPD |
|
Almost the same speed as the tachometer indication | |||||
| VEHICLE SPEED |
|
Almost the same speed as the speedometer indication | |||||
| IDL A/V LEARN |
|
Idle air volume learning has not been performed yet. | YET | ||||
| Idle air volume learning has already been performed successfully. | CMPLT | ||||||
| SNOW MODE SW |
|
Snow mode switch: Pressed | ON | ||||
| Snow mode switch: Released | OFF | ||||||
| ENG OIL TEMP |
|
More than 70°C (158°F) | |||||
| TRVL AFTER MIL |
|
Vehicle has traveled after MIL has illuminated. | 0 - 65, 535 km (0 - 40, 723 miles) | ||||
| A/F S1 HTR (B1) |
|
4 - 100% | |||||
| A/F S1 HTR (B2) |
|
4 - 100% | |||||
| AC PRESS SEN |
|
1.0 - 4.0 V | |||||
| VHCL SPEED SE |
|
Almost the same speed as the speedometer indication | |||||
| SET VHCL SPD |
|
ASCD: Operating | The preset vehicle speed is displayed | ||||
| MAIN SW |
|
MAIN switch: Pressed | ON | ||||
| MAIN switch: Released | OFF | ||||||
| CANCEL SW |
|
CANCEL switch: Pressed | ON | ||||
| CANCEL switch: Released | OFF | ||||||
| RESUME/ACC SW |
|
RESUME/ACCELERATE switch: Pressed | ON | ||||
| RESUME/ACCELERATE switch: Released | OFF | ||||||
| SET SW |
|
SET/COAST switch: Pressed | ON | ||||
| SET/COAST switch: Released | OFF | ||||||
| BRAKE SW1 (ICC/ASCD brake switch) |
|
Brake pedal: Fully released | ON | ||||
| Brake pedal: Slightly depressed | OFF | ||||||
| BRAKE SW2 (Stop lamp switch) |
|
Brake pedal: Fully released | OFF | ||||
| Brake pedal: Slightly depressed | ON | ||||||
| DIST SW |
|
DISTANCE switch: Pressed | ON | ||||
| DISTANCE switch: Released | OFF | ||||||
| CRUISE LAMP |
|
MAIN switch: Pressed at the 1st time → at the 2nd time | ON → OFF | ||||
| BAT CUR SEN |
|
Approx. 2, 600 - 3, 500 mV | |||||
| MAP SENSOR |
|
Idle | Approx. 1.0 V | ||||
| 2, 000 RPM | Approx. 1.35 V | ||||||
| ALT DUTY |
|
0 - 80% | |||||
| BRAKE BST PRES SE |
|
||||||
| VVEL POSITION SEN-B1 |
|
Idle | Approx. 0.25 - 1.40 V | ||||
| When revving engine up to 2, 000 RPM quickly | Approx. 0.25 - 4.75 V | ||||||
| VVEL POSITION SEN-B2 |
|
Idle | Approx. 0.25 - 1.40 V | ||||
| When revving engine up to 2, 000 RPM quickly | Approx. 0.25 - 4.75 V | ||||||
| VVEL TIM-B1 |
|
Idle | Approx. 0 - 20 deg | ||||
| When revving engine up to 2, 000 RPM quickly | Approx. 0 - 90 deg | ||||||
| VVEL TIM-B2 |
|
Idle | Approx. 0 - 20 deg | ||||
| When revving engine up to 2, 000 RPM quickly | Approx. 0 - 90 deg | ||||||
| VVEL LEARN |
|
VVEL learning has not been performed yet. | YET | ||||
| VVEL learning has already been performed successfully. | DONE | ||||||
| VVEL SEN LEARN-B1 |
|
Approx. 0.30 - 0.80 V | |||||
| VVEL SEN LEARN-B2 |
|
Approx. 0.30 - 0.80 V | |||||
| A/F ADJ-B1 |
|
-0.330 - 0.330 | |||||
| A/F ADJ-B2 |
|
-0.330 - 0.330 | |||||
| FAN DUTY |
|
0 - 100% | |||||
| ALT DUTY SIG |
|
ON | |||||
|
OFF | ||||||
| BAT TEMP SEN |
|
Idle | Indicates the temperature around the battery. | ||||
| EVAP LEAK DIAG |
|
Depending on condition of EVAP leak diagnosis | |||||
| EVAP DIAG READY |
|
Depending on ready condition of EVAP leak diagnosis | |||||
| HO2 S2 DIAG1 (B1) | DTC P0139 self-diagnosis (delayed response) is incomplete. | INCMP | |||||
| DTC P0139 self-diagnosis (delayed response) is complete. | CMPLT | ||||||
| HO2 S2 DIAG1 (B2) | DTC P0159 self-diagnosis (delayed response) is incomplete. | INCMP | |||||
| DTC P0159 self-diagnosis (delayed response) is complete. | CMPLT | ||||||
| HO2 S2 DIAG2 (B1) | DTC P0139 self-diagnosis (slow response) is incomplete. | INCMP | |||||
| DTC P0139 self-diagnosis (slow response) is complete. | CMPLT | ||||||
| HO2 S2 DIAG2 (B2) | DTC P0159 self-diagnosis (slow response) is incomplete. | INCMP | |||||
| DTC P0159 self-diagnosis (slow response) is complete. | CMPLT | ||||||
| A/F SEN1 DIAG2 (B1) |
|
||||||
| A/F SEN1 DIAG2 (B2) |
|
||||||
| THRTL STK CNT B1 |
|
||||||
| THRTL STK CNT B2 |
|
||||||
|
|||||||