Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONTINUITY CAMERA IMAGE SIGNAL CIRCUIT

Turn ignition switch OFF.
Disconnect front display unit connector and around view monitor control unit connector.

Check continuity between front display unit harness connector and around view monitor control unit harness connector.

CONTINUITY SPECIFICATION

Front display unit		Around view monitor control unit		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M215	8	M48	27	Existed

Check continuity between front display unit harness connector and ground.

CONTINUITY SPECIFICATION

Front display unit		Ground	Continuity
Connector	Terminal
M215	8		Not existed

Is inspection result normal?

YES: Go to 2.

NO: Repair harness or connector.

CHECK CAMERA IMAGE SIGNAL

Connect front display unit connector and around view monitor control unit connector.
Turn ignition switch ON.

Check signal between front display unit harness connector and ground.

SIGNAL REFERENCE

(+)		(-)	Condition	Reference value
Front display unit
Connector	Terminal
M215	8	Ground	At camera image is displayed.	Courtesy of NISSAN MOTOR CO., U.S.A.

Is inspection result normal?

YES: Replace front display unit. Refer to "REMOVAL AND INSTALLATION ".

NO: Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".