LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2011 >> M37 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Audio, Visual & Navigation System) >> DTC/Circuit Diagnosis >> Side Camera RH Image Signal Circuit >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CONTINUITY SIDE CAMERA RH POWER SUPPLY AND GROUND CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect control unit connector and door mirror (passenger side) connector.
    3. Check continuity between around view monitor control unit harness connector and door mirror (passenger side) harness connector.
      CONTINUITY SPECIFICATION

      Around view monitor control unit Door mirror (passenger side) Continuity
      Connector Terminals Connector Terminals
      M48 32 D23 18 Existed
      34 6
    4. Check continuity between around view monitor control unit harness connector and ground.
      CONTINUITY SPECIFICATION

      Around view monitor control unit Ground Continuity
      Connector Terminal
      M48 34 Not existed

      Is inspection result normal? 

      YES: Go to 2.

      NO: Repair harness or connector.

  2. CHECK VOLTAGE SIDE CAMERA RH POWER SUPPLY
    1. Connect around view monitor control unit connector and door mirror (passenger side) connector.
    2. Turn ignition switch ON.
    3. Check voltage between around view monitor control unit harness connector and ground.
      VOLTAGE SPECIFICATION

      (+) (-) Condition Voltage (Approx.)
      Around view monitor control unit
      Connector Terminal
      M48 34 Ground "CAMERA" switch is ON or shift position is "R". 6.0 V

      Is inspection result normal? 

      YES: Go to 3.

      NO: Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".

  3. CHECK CONTINUITY SIDE CAMERA RH IMAGE SIGNAL CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect around view monitor control unit connector and door mirror (passenger side) connector.
    3. Check continuity between around view monitor control unit harness connector and door mirror (passenger side) harness connector.
      CONTINUITY SPECIFICATION

      Around view monitor control unit Door mirror (passenger side) Continuity
      Connector Terminals Connector Terminals
      M48 29 D23 5 Existed
      30 17
    4. Check continuity between around view monitor control unit harness connector and ground.
      CONTINUITY SPECIFICATION

      Around view monitor control unit Ground Continuity
      Connector Terminals
      M48 29, 30 Not existed

      Is inspection result normal? 

      YES: Go to 4.

      NO: Repair harness or connector.

  4. CHECK SIDE CAMERA RH IMAGE SIGNAL
    1. Connect around view monitor control unit connector and door mirror (passenger side) connector.
    2. Turn ignition switch ON.
    3. Check signal between around view monitor control unit harness connector.
      SIGNAL REFERENCE

      (+) (-) Condition Reference value
      Around view monitor control unit Around view monitor control unit
      Connector Terminal Connector Terminal
      M48 29 B48 30 "CAMERA" switch is ON or shift position is "R".
      G05732118Courtesy of NISSAN MOTOR CO., U.S.A.

      Is inspection result normal? 

      YES: Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".

      NO: Replace side camera RH. Refer to "REMOVAL AND INSTALLATION ".

scientia non olet · About LEMON Manuals