Work Procedure

WARNING: This page is about a different car, the 2011 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION: Fully understand the following items well before the road test;

Precautions: Refer to "PRECAUTION FOR BSW SYSTEM SERVICE ".
System description: Refer to "SYSTEM DESCRIPTION ".
Normal operating condition: Refer to "DESCRIPTION ".

BSW SYSTEM ACTION TEST

Drive the vehicle.
Turn warning systems switch ON (warning systems ON indicator is ON).

Check BSW operation according to the following table.

VEHICLE CONDITION/DRIVER'S OPERATION

Vehicle condition/Driver's operation				Action
Warning systems ON indicator	Vehicle speed (Approx.) [km/h (MPH)]	Turn signal condition	Status of vehicle detection within detection area	Indication on the BSW indicator	Buzzer
OFF	-	-	-	OFF	OFF
ON	Less than approx. 29 (18)	-	-	OFF	OFF
	Approx. 32 (20) or more	-	Vehicle is absent	OFF	OFF
		OFF	Vehicle is detected	ON	OFF
		ON (vehicle detected direction)	Before turn signal operates Vehicle is detected	Blink Courtesy of NISSAN MOTOR CO., U.S.A.	Short continuous beep Courtesy of NISSAN MOTOR CO., U.S.A.
		ON (vehicle detected direction)	Vehicle is detected after turn signal operates	Blink Courtesy of NISSAN MOTOR CO., U.S.A.	OFF

NOTE:

If vehicle speed exceeds approximately 32 km/h (20MPH), BSW function operates until the vehicle speed becomes lower than approximately 29km/h (18MPH).
Time shown in the figure is approximate time.

INSPECTION END