Data Monitor
WARNING: This page is about a different car, the 2012 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
| Monitor Item | Condition | ||
|---|---|---|---|
| REQ SW-DR | Indicates [On/Off] condition of door request switch (driver side) | ||
| REQ SW-AS | Indicates [On/Off] condition of door request switch (passenger side) | ||
| REQ SW-BD/TR | Indicates [On/Off] condition of back door request switch | ||
| PUSH SW | Indicates [On/Off] condition of push-button ignition switch | ||
| CLUTCH SW |
NOTE:
This item is displayed, but cannot be monitored
|
||
| BRAKE SW 1 | Indicates [On/Off](1) condition of stop lamp switch power supply | ||
| BRAKE SW 2 | Indicates [On/Off] condition of stop lamp switch | ||
| DETE/CANCL SW | Indicates [On/Off] condition of P position | ||
| SFT PN/N SW | Indicates [On/Off] condition of P or N position | ||
| S/L-LOCK |
NOTE:
This item is displayed, but cannot be monitored
|
||
| S/L-UNLOCK |
NOTE:
This item is displayed, but cannot be monitored
|
||
| S/L RELAY-F/B |
NOTE:
This item is displayed, but cannot be monitored
|
||
| UNLK SEN-DR | Indicates [On/Off] condition of driver door UNLOCK status | ||
| PUSH SW-IPDM | Indicates [On/Off] condition of push-button ignition switch | ||
| IGN RLY1-F/B | Indicates [On/Off] condition of ignition relay 1 | ||
| DETE SW-IPDM | Indicates [On/Off] condition of P position | ||
| SFT PN-IPDM | Indicates [On/Off] condition of P or N position | ||
| SFT P-MET | Indicates [On/Off] condition of P position | ||
| SFT N-MET | Indicates [On/Off] condition of N position | ||
| ENGINE STATE | Indicates [Stop/Stall/Crank/Run] condition of engine states | ||
| S/L LOCK-IPDM |
NOTE:
This item is displayed, but cannot be monitored
|
||
| S/L UNLK-IPDM |
NOTE:
This item is displayed, but cannot be monitored
|
||
| S/L RELAY-REQ |
NOTE:
This item is displayed, but cannot be monitored
|
||
| VEH SPEED 1 | Display the vehicle speed signal received from combination meter by numerical value [Km/h] | ||
| VEH SPEED 2 | Display the vehicle speed signal received from ABS or VDC or TCM by numerical value [Km/h] | ||
| DOOR STAT-DR | Indicates [LOCK/READY/UNLK] condition of unlock sensor | ||
| DOOR STAT-AS | Indicates [LOCK/READY/UNLK] condition of passenger side door status | ||
| ID OK FLAG | Indicates [Set/Reset] condition of key ID | ||
| PRMT ENG STRT | Indicates [Set/Reset] condition of engine start possibility | ||
| PRMT RKE STRT |
NOTE:
This item is displayed, but cannot be monitored
|
||
| TRNK/HAT MNTR |
NOTE:
This item is displayed, but cannot be monitored
|
||
| RKE-LOCK | Indicates [On/Off] condition of LOCK signal from Intelligent Key | ||
| RKE-UNLOCK | Indicates [On/Off] condition of UNLOCK signal from Intelligent Key | ||
| RKE-TR/BD |
NOTE:
This item is displayed, but cannot be monitored
|
||
| RKE-PANIC | Indicates [On/Off] condition of PANIC button of Intelligent Key | ||
| RKE-MODE CHG | Indicates [On/Off] condition of MODE CHANGE signal from Intelligent Key | ||
| RKE OPE COUN1 | When remote keyless entry receiver receives the signal transmitted while operating on Intelligent Key, the numerical value start changing | ||
| RKE OPE COUN2 |
NOTE:
This item is displayed, but cannot be monitored
|
||
|
|||