Low Power Consumption Control With BCM
WARNING: This page is about a different car, the 2013 Infiniti M56 and 2013 Infiniti M37. However, it is still accessible from the selected car via links, so may be relevant.
BCM reduces the power consumption with the following operation in the low power consumption mode.
- The reading interval of the each switches changes from 10 ms interval to 60 ms interval.
Sleep mode activation
- BCM receives the sleep-ready signal (ready) from IPDM E/R and combination meter via CAN communication.
- BCM transmits the sleep wake up signal (sleep) to each unit when all of the CAN sleep conditions are fulfilled.
- Each unit stops the transmission of CAN communication with the sleep wake up signal. BCM is in CAN communication sleep mode.
- BCM is in the low power consumption mode and perform the low power consumption control when all of the BCM sleep conditions are fulfilled with CAN sleep condition.
SLEEP CONDITION
| CAN sleep condition |
BCM sleep condition |
- Receiving the sleep-ready signal (ready) from all units
- Ignition switch: OFF
- Vehicle security system and panic alarm: Not operation
- Warning chime: Not operation
- Intelligent Key system buzzer: Not operation
- Trunk lid open/close status: No change
- Stop lamp switch: OFF
- ICC brake hold relay (with ICC): OFF
- Turn signal indicator lamp: Not operation
- Exterior lamp: OFF
- Door lock status: No change
- CONSULT communication status: Not communication
- Meter display signal: Non-transmission
- Door switch status: No change
- Rear window defogger: OFF
|
- Interior room lamp battery saver: Time out
- RAP system: OFF
- Infiniti Vehicle Immobilizer System (IVIS) - NATS: Not operation
- Remote keyless entry receiver communication status: No communication
- LOCK indicator lamp: Not operation
- ACC indicator lamp: Not operation
- ON indicator lamp: Not operation
|
Wake-up operation
- BCM transmits sleep wake up signal (wake up) to each unit when any condition listed below is established, and then goes into normal mode from low power consumption mode.
- Each unit starts transmissions with CAN communication by receiving sleep wake up signals. Each unit transmit wake up signals to BCM with CAN communication to convey the start of CAN communication.
WAKE-UP CONDITION
| BCM wake-up condition |
CAN wake-up condition |
| Trunk lid opener switch: OFF → ON |
- Receiving the sleep-ready signal (Not-ready) from any units
- Push-button ignition switch (push switch): OFF→ ON
- Hazard switch: ON
- HI BEAM switch: OFF → ON, ON → OFF
- PASSING switch: OFF → ON, ON → OFF
- HEADLAMP 1 switch: OFF → ON, ON → OFF
- HEADLAMP 2 switch: OFF → ON, ON → OFF
- TAIL LAMP switch: OFF → ON
- FR FOG switch: OFF → ON, ON → OFF
- TURN RH: OFF → ON, ON → OFF
- TURN LH: OFF → ON, ON → OFF
- Driver door switch: OFF → ON, ON → OFF
- Passenger door switch: OFF → ON, ON → OFF
- Rear RH door switch: OFF → ON, ON → OFF
- Rear LH door switch: OFF → ON, ON → OFF
- Trunk lid open/close status: OFF → ON, ON → OFF
- Driver door request switch: OFF → ON
- Passenger door request switch: OFF → ON
- Trunk lid opener request switch: OFF → ON
- Stop lamp switch: ON
- ICC brake hold relay (with ICC): ON
- Remote keyless entry receiver communication: Receiving
- Front door lock assembly (driver side) (unlock sensor): OFF → ON, ON → OFF
|