Diagnosis Procedure
WARNING: This page is about a different car, the 2012 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONTINUITY FRONT CAMERA POWER SUPPLY AND GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit connector and front camera connector.
- Check continuity between around view monitor control unit harness connector and front camera harness connector.
Around view monitor control unit Front camera Continuity Connector Terminals Connector Terminals M49 44 E50 2 Existed 46 1 - Check continuity between around view monitor control unit harness connector and ground.
Around view monitor control unit Ground Continuity Connector Terminal M49 46 Not existed Is inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK VOLTAGE FRONT CAMERA POWER SUPPLY
- Connect around view monitor control unit connector and front camera connector.
- Turn ignition switch ON.
- Check voltage between around view monitor control unit harness connector.
(+) (-) Condition Voltage (Approx.) Around view monitor control unit Connector Terminal M49 46 Ground "CAMERA" switch is ON or shift position is "R". 6.0 V Is inspection result normal?
YES: GO TO 3.
NO: Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".
- CHECK CONTINUITY FRONT CAMERA IMAGE SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit connector and front camera connector.
- Check continuity between around view monitor control unit harness connector and front camera harness connector.
Around view monitor control unit Front camera Continuity Connector Terminals Connector Terminals M49 41 E50 3 Existed 42 4 - Check continuity between around view monitor control unit harness connector and ground.
Around view monitor control unit Ground Continuity Connector Terminals M49 41, 42 Not existed Is inspection result normal?
YES: GO TO 4.
NO: Repair harness or connector.
- CHECK FRONT CAMERA IMAGE SIGNAL
- Connect around view monitor control unit connector and front camera connector.
- Turn ignition switch ON.
- Check signal between around view monitor control unit harness connector.
(+) (-) Condition Reference value Around view monitor control unit Connector Terminal Connector Terminal M49 41 M49 42 "CAMERA" switch is ON or shift position is "R". Is inspection result normal?
YES: Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".
NO: Replace front camera. Refer to "REMOVAL AND INSTALLATION ".