Brake Actuator: Notes

WARNING: This page is about a different car, the 2012 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The test can be performed only when the engine is running.

Test item	Operation	Description	"PRESS SENS" value
BRAKE ACTUATOR	MODE1	Transmits the brake fluid pressure control signal to the ABS actuator and electric unit (control unit) via CAN communication	10 bar
	MODE2		20 bar
	MODE3		30 bar
	Test start	Starts the tests of "MODE1", "MODE2" and "MODE3"	-
	Reset	Stops transmitting the brake fluid pressure control signal below to end the test	-
	End	Returns to the "SELECT TEST ITEM" screen	-

NOTE: The test is finished in 10 seconds after starting

Fig 1: ADAS Control Unit Brake Actuator Modes

Courtesy of NISSAN NORTH AMERICA, INC.