Operation Condition

Once the following condition from below is established, alert or warning is executed.

OPERATION CONDITION

Warning/Information functions

Operation procedure

Intelligent Key system malfunction

When a malfunction is detected on BCM, "KEY" warning lamp illuminates

OFF position warning

For internal

Ignition switch: ACC position
Door switch (driver side): ON (Door is open)

For external

OFF position warning (For internal) is in active mode, driver side door is closed

NOTE: OFF position (For external) active only when each of the sequence occurs as below: P position warning → ACC warning → OFF position warning (For internal) → OFF position warning (For internal)

P position warning

For internal

Shift position: Except P position
Engine is running to stopped (Ignition switch is ON to OFF)

For external

Warning is activated when driver door is closed from the open position while the P position warning (for inside vehicle) is ON

ACC warning

When P position warning is in active mode, shift position changes P position
Ignition switch: ACC position

Take away warning

Door is open to close

Ignition switch: Except LOCK position
Door switch: ON to OFF (Door is open to close)
Intelligent Key cannot be detected inside the vehicle

Door is open

Door switch: ON (Door is open)
Key ID verification every 5 seconds when registered Intelligent Key cannot be detected inside the vehicle

Push-button ignition switch operation

Ignition switch: Except LOCK position
Press push-button ignition switch
Intelligent Key cannot be detected inside the vehicle

Door lock operation warning

When door lock operation is requested while door lock operating condition of door request switch or Intelligent Key are not satisfied

Engine start information

Ignition switch is ON position

Ignition switch: ON position
Shift position: P position⁽¹⁾
Engine is stopped

Ignition switch is except ON position

Ignition switch: Except ON position
Shift position: P position⁽¹⁾
Intelligent Key is inserted in key slot or Intelligent Key can be detected inside the vehicle

Steering lock information

When steering lock cannot be released after ignition switch is turned ON

Intelligent Key low battery warning

When Intelligent Key is low battery, BCM is detected after ignition switch is turned ON

Key ID warning

When registered Intelligent Key cannot be detected inside the vehicle after ignition switch is turned ON

Key ID verification information

When registered Intelligent Key cannot be detected inside the vehicle
Intelligent Key battery is discharged
When NATS antenna amp cannot be detected NATS ID

⁽¹⁾	If the registered Intelligent Key is used, the operation can be performed even if the back door is in the LOCK position