DRIVER SIDE: Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect front power window motor (driver side) connector.
3. Turn ignition switch ON.
4. Check voltage between front power window motor (driver side) harness connector and ground.

   (+)		(-)	Condition		Voltage (V) (Approx.)
   Front power window motor (driver side)
   Connector	Terminal
   D10	2	Ground	Power window main switch	UP	Battery voltage
   				DOWN	0
   	1			UP	0
   				DOWN	Battery voltage

   Is the measurement value within the specification? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect power window main switch connector.
3. Check continuity between power window main switch harness connector and front power window motor (driver side) harness connector.

   Power window main switch		Front power window motor (driver side)		Continuity
   Connector	Terminal	Connector	Terminal
   D8	8	D10	2	Existed
   	11		1

4. Check continuity between power window main switch harness connector and ground.

   Power window main switch		Ground	Continuity
   Connector	Terminal
   D8	8		Not existed
   	11

   Is the inspection result normal? 

   YES: Replace power window main switch. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Check front power window motor (driver side).

Refer to "DRIVER SIDE: COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Replace front power window motor (driver side). Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

: INSPECTION END