Component Inspection (ICC Brake Hold Relay)

WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ICC BRAKE HOLD RELAY

Turn ignition switch OFF.
Remove ICC brake hold relay.
Check the continuity between ICC brake hold relay terminals under the following conditions.

CONTINUITY SPECIFICATION

Terminal	Condition	Continuity
3 and 4	12 V direct current supply between terminal 1 and 2	Not existed
3 and 4	No current supply	Existed
6 and 7	12 V direct current supply between terminal 1 and 2	Existed
6 and 7	No current supply	Not existed

Fig 1: Identifying ICC Brake Hold Relay Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace ICC brake hold relay.