Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect push-button ignition switch connector.
3. Check voltage between push-button ignition switch harness connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   Push-button ignition switch
   Connector	Terminal
   M50	8	Ground	Battery voltage

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Check the following:

   • 10A fuse [No. 9, located in fuse block (J/B)]
   • Harness for open or short between push-button ignition switch and fuse
   • If NG, repair or replace fuse or harness

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and push-button ignition switch harness connector.

   Indicator	BCM		Push-button ignition switch		Continuity
   	Connector	Terminal	Connector	Terminal
   LOCK	M123	134	M50	5	Existed
   ACC	M119	15		6
   ON	M122	93		7

3. Check continuity between BCM harness connector and ground.

   Indicator	BCM		Ground	Continuity
   	Connector	Terminal
   LOCK	M123	134		Not existed
   ACC	M119	15
   ON	M122	93

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair or replace harness.

Refer to "INTERMITTENT INCIDENT ".

: INSPECTION END