DTC Confirmation Procedure

INSPECTION START
Will CONSULT be used?

Will CONSULT be used?

YES: GO TO 2.

NO: GO TO 4.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test:
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  NOTE: After repair, check that the hoses and clips are installed properly.
  
  TESTING CONDITION:
  - Open engine hood before conducting the following procedure:
  - If any of following conditions are met just before the DTC confirmation procedure, leave the vehicle for more than 1 hour:
    - Fuel filler cap is removed.
    - Fuel is refilled or drained.
    - EVAP component part/parts is/are removed.
  - Before performing the following procedure, confirm that battery voltage is more than 11 V at idle:
  - Check that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.
  : GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
2. Check that the following conditions are met:
  FUEL LEVEL SE: 0.25 - 1.4 V
  
  COOLAN TEMP/S: 0 - 32°C (32 - 90°F)
  
  FUEL T/TMP SE: 0 - 35°C (32 - 95°F)
  
  INT A/TEMP SE: More than 0°C (32°F)
  
  If NG, turn ignition switch OFF and leave the vehicle in a cool place (soak the vehicle), or refill/drain fuel until the output voltage condition of the "FUEL LEVEL SE" meets within the range above and leave the vehicle for more than 1 hour. Then start from step 1.
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Turn ignition switch ON.
5. Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.
  Follow the instructions displayed.
  
  NOTE: If the engine speed cannot be maintained within the range displayed on CONSULT screen, go to "BASIC INSPECTION: SPECIAL REPAIR REQUIREMENT ".
  
  Which is displayed on CONSULT screen?
  
  OK: INSPECTION END
  
  NG: Proceed to "DIAGNOSIS PROCEDURE ".
PERFORM COMPONENT FUNCTION CHECK
With GST

Perform component function check. Refer to "COMPONENT FUNCTION CHECK ".

NOTE: Use component function check to check the overall function of the EVAP very small leak function. During this check, a 1st trip DTC might not be confirmed.

Is the inspection result normal?

YES: INSPECTION END

NO: Proceed to "DIAGNOSIS PROCEDURE ".