Component Function Check
WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUNCTION
- Turn ignition switch ON.
- Select "TELESCO SEN" in "Data monitor" mode with CONSULT-III.
- Check the tilt sensor signal under the following conditions.MONITOR ITEM CONDITION
Monitor item Condition Value TELESCO SEN Telescopic position Change between
0.8 [V] (close to top)
3.4 [V] (close to bottom)Is the indication normal?
YES: INSPECTION END.
NO: Perform diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".