ID Registration With Transmitter Activation Tool

1. With the ignition switch in OFF position, connect CONSULT-III to the Data Link Connector (DLC).
2. Turn ignition switch to ON position.
3. Display the "WORK SUPPORT" screen and select "ID REGIST". Select "START " on the "ID REGIST" screen.
4. With the Transmitter Activation Tool (J-45295) pushed against the front left tire transmitter/air valve, press the button for 5 seconds. See Fig 1.
5. Register the IDs in the specified order. See ID REGISTRATION ORDER SPECIFICATIONS  table. When ID registration of each wheel has been completed, the turn signal lights blink.
   ID Registration Order Specifications
   
   

   Tire Position	Turn Signal Will Flash	CONSULT-III
   Front Left	2 Times	From RED To GREEN
   Front Right	2 Times	From RED To GREEN
   Rear Right	2 Times	From RED To GREEN
   Rear Left	2 Times	From RED To GREEN

   NOTE: Be sure to register the IDs in the specified order, or the self-diagnostic results display will not function properly.
6. After completing all ID registrations, press "END" to complete the procedure.

Fig 1: Identifying Transmitter Activation Tool (J-45295)

Courtesy of NISSAN MOTOR CO., U.S.A.