DTC Reproduction Procedure
CAUTION:
If the CAN signal "Unavailable" or "Broken" is received while the battery voltage is in the low (between 6 V and 9 V) condition, and when intending to perform another self-diagnosis operation to record the DTC history, always start the procedure after checking that the battery voltage is within the specified normal value.
- CHECK E-SUS CONTROL UNIT SIGNAL
With CONSULT-III
- Start the engine.CAUTION: Always hold the vehicle stopped.
- Select "DATA MONITOR" of "E-SUS".
- Check the value of "IGN" on "DATA MONITOR" screen.
Is the value in "DATA MONITOR" "between 6 V and 9 V" or more?
YES: GO TO 2.
NO: Perform the diagnosis for the charging system. Refer to "SYMPTOM TABLE ".
- Start the engine.
- DTC REPRODUCTION PROCEDURE
With CONSULT-III
Perform "E-SUS" self-diagnosis.
Is DTC "C1D03" detected?
YES: Proceed to diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END