DTC Confirmation Procedure

INSPECTION START
Is it necessary to erase permanent DTC?

YES: GO TO 7.

NO: GO TO 2.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test:
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  : GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE-I
1. Turn ignition switch ON and wait at least 10 seconds.
2. Check 1st trip DTC.
  Is 1st trip DTC detected?
  
  YES: Proceed to "DIAGNOSIS PROCEDURE ".
  
  NO: GO TO 4.
CHECK ENGINE COOLANT TEMPERATURE
With CONSULT
1. Select "COOLAN TEMP/S" in "DATA MONITOR" with CONSULT.
2. Check "COOLAN TEMP/S" value.
  "COOLAN TEMP/S" less than 60°C (140°F)?
  
  YES: INSPECTION END
  
  NO: GO TO 5.
PERFORM DTC CONFIRMATION PROCEDURE-II
1. Cool engine down until "COOLAN TEMP/S" is less than 60°C (140°F).
2. Wait at least 10 seconds.
3. Check 1st trip DTC.
  Is 1st trip DTC detected?
  
  YES: Proceed to "DIAGNOSIS PROCEDURE ".
  
  NO: GO TO 6.
PERFORM COMPONENT FUNCTION CHECK (FOR MALFUNCTION B)
Perform component function check. Refer to "COMPONENT FUNCTION CHECK ".

NOTE: Use the component function check to check the overall function of the FTT sensor circuit. During this check, a 1st trip DTC might not be confirmed.

Is the inspection result normal?

YES: INSPECTION END

NO: Proceed to "DIAGNOSIS PROCEDURE ".
PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test:
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TEST CONDITION:
  - Before performing the following procedure, do not add fuel.
  - Before performing the following procedure, check that fuel level is between 1/4 and 4/4.
  - Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.
    : GO TO 8.
PERFORM DTC CONFIRMATION PROCEDURE B
1. Start engine and let it idle for 60 minutes.
2. Move the vehicle to a cool place.
  NOTE: Cool the vehicle in an environment of ambient air temperature between -10°C (14°F) and 35°C (95°F).
3. Turn ignition switch OFF and soak the vehicle for 12 hours.
  CAUTION: Never turn ignition switch ON during soaking.
  
  NOTE: The vehicle must be cooled with the food open.
4. Start engine and let it idle for 5 minutes or more.
  CAUTION: Never turn ignition switch OFF during idling.
5. Check 1st trip DTC.
  Is 1st trip DTC detected?
  
  YES: Proceed to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END