Detailed Flow

WARNING: This page is about a different variant/trim than selected.

INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, reproduce symptoms, and understand them fully. Ask customer about his/her complaints carefully. Check symptoms by driving vehicle with customer, if necessary.

CAUTION: Customers are not professional. Never guess easily like "maybe the customer means that...," or "maybe the customer mentions this symptom".

: GO TO 2.
CHECK AWD WARNING LAMP
Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.

Does AWD warning lamp turn ON?

YES: GO TO 3.

NO: GO TO 6.
PERFORM SELF-DIAGNOSIS
With CONSULT
1. Perform self-diagnosis for "ALL MODE AWD/4WD".
2. Check malfunction detected by self-diagnosis.
3. Erase self-diagnostic results for "ALL MODE AWD/4WD".
  : GO TO 4.
CHECK TERMINALS AND HARNESS CONNECTORS
Check pin terminals for damage or loose connection with harness connector.

: GO TO 5.
CHECK SYMPTOM REPRODUCTION
With CONSULT

Perform DTC reproduction procedure for the error system.

Is any error detected?

YES: GO TO 2.

NO: GO TO 6.
PERFORM SYMPTOM DIAGNOSIS
Perform the symptom diagnosis for each system.

Is any malfunction present?

YES: GO TO 2.

NO: GO TO 7.
FINAL CHECK
With CONSULT

Check input/output signal standard of "ALL MODE AWD/4WD".

Is the input/output the standard value?

YES: INSPECTION END

NO: GO TO 2.