LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> G25 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Engine Control System - 370Z - Diagnostics Introduction & DTC Index) >> Basic Inspection >> Inspection And Adjustment >> M/T Neutral Position Learning >> M/T NEUTRAL POSITION LEARNING : Special Repair Requirement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

M/T NEUTRAL POSITION LEARNING : Special Repair Requirement

WARNING: This page is about a different car, the 2011 Nissan 370Z. However, it is still accessible from the selected car via links, so may be relevant.
  1. START

    Do you have CONSULT-III?

    Do you have CONSULT-III? 

    YES: Go to 2.

    NO: Go to  3.

  2. PERFORM M/T NEUTRAL POSITION LEARNING

    With CONSULT-III 

    1. Check that there is no sticking when shifting shift lever to the neutral position.
    2. Turn ignition switch ON.
    3. Select "M/T NEUTRAL POS LEARN" in "WORK SUPPORT" mode with CONSULT-III.
    4. Touch "Start" and wait a few seconds.
      NOTE: Never touch shift lever. Otherwise learning may not complete normally.
    5. Make sure the "COMPLETE" is displayed on CONSULT-III screen.
    NOTE: If "INCMP" is displayed, return to step 1 and repeat the procedures again.

    END

  3. PERFORM M/T NEUTRAL POSITION LEARNING

    Without CONSULT-III 

    NOTE:
    • It is better to count the time accurately with a clock.
    • It is impossible to switch the learning mode when a clutch interlock switch circuit has a malfunction.
    1. Check that there is no sticking when shifting shift lever to the neutral position.
    2. Turn ignition switch ON and wait 5 seconds.
    3. Within 5 seconds repeat the following operation 3 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
    4. Wait 3 seconds while S-MODE switch is released.
    5. Wait 5 seconds while pressing S-MODE switch.
    6. Wait 3 seconds while S-MODE switch is released.
    7. Within 5 seconds repeat the following operation 5 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.

      ECM starts M/T Neutral Position Learning.

      NOTE: Never touch shift lever. Otherwise learning may not complete normally.
      Fig 1: M/T Neutral Position Timing Chart
      G07099507Courtesy of NISSAN MOTOR CO., U.S.A.
    8. Shift position indicator on combination meter blinks for 5 seconds when the leaning is complete.
    NOTE: If shift position indicator does not blink or blinks continuously, return to step 1 and repeat the procedures again.

    END

scientia non olet · About LEMON Manuals